TL AWD V6-3.7L (2010)
Carpet: Service and Repair
Rear Carpet Replacement
Rear Carpet Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to damage, wrinkle or twist the carpet.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Remove these items:
-
Front seats, both sides See: Seats/Service and Repair/Front Seat Removal/Installation
-
Front door sill trims, both sides See: Scuff Plate/Service and Repair
-
Rear door sill trims, both sides See: Scuff Plate/Service and Repair
-
Center console See: Console/Service and Repair/Removal and Replacement/Center Console Removal/Installation
-
Rear seat cushion See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Shift cable See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair
-
Shift lever bracket base See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and Repair/Removal and
Replacement/A/T Shift Lever Removal
2. Remove the bolts, then remove the yaw rate-lateral/(longitudinal) acceleration sensor mounting bracket (A). Detach the harness clips (C), and
remove the TORX ground bolt (D) with a TORX T30 bit. Disconnect the SRS unit connector B.
3. Remove the clips (A) securing the front carpet (B) and the rear carpet (C).