TL AWD V6-3.7L (2010)
4. Place a floor jack under the connecting point of the knuckle and lower arm A, and raise the suspension to load it with the vehicle's weight.
5. Tighten the damper lower mounting bolt and the brake hose bracket mounting nuts to the specified torque.
6. Tighten the damper mounting nuts on top of the damper to the specified torque.
7. Install the brake hose mounting bolt (A), and tighten the mounting bolt to the specified torque.
8. Install the rear seat See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation.
9. Clean the mating surfaces of the brake disc/drum and the inside of the wheel, then install the rear wheel.
10. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
