TL FWD V6-3.5L (2009)
10. Tighten the bolts in three steps. In the final step tighten all bolts, in sequence, 12 N-m (1.2 kgf-m, 8.7 lbf-ft).
11. Install the harness holder (A) to the bracket.
12. Connect the exhaust gas recirculation (EGR) valve connector (B) and install the harness holder mounting bolt (C) and the harness clamp (D).
13. Install the three ignition coils to the front cylinder head. See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair
14. Install the intake manifold. See: Intake Manifold/Service and Repair/Intake Manifold Removal and Installation
Rear
1. Check the spark plug seals for damage. If any seal is damaged, replace it.
2. Thoroughly clean the head cover gasket and the groove.
3. Install the head cover gasket (A) in the groove of the cylinder head cover (B). Make sure the head cover gasket is seated securely.
4. Remove all of the old liquid gasket from the rocker shaft holder and the cylinder head.
5. Clean the head cover contacting surfaces with a shop towel.
