TL FWD V6-3.5L (2009)
6. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the rocker shaft holder mating areas (A). Install the
component within 5 minutes of applying the liquid gasket.
NOTE:
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
7. Set the spark plug seals (A) on the spark plug tubes, and install the rear cylinder head cover (B).
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the cylinder head cover.
8. Inspect the spark plug seals for damage.
9. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
10. Tighten the bolts in three steps. In the final step tighten all bolts, in sequence, 12 N-m (1.2 kgf-m, 8.7 lbf-ft).
