TL FWD V6-3.5L (2009)
11. Connect the knock sensor connector (A) and the camshaft position (CMP) sensor connector (B) and install the harness holder mounting bolts (C).
12. Install the engine hanger bracket (A).
13. Install the harness (B) to the upper cover.
14. Connect the breather hose (C) and install the harness clamp (D).
15. Reconnect the three injector connectors (E) and the two harness clamps (F).
16. Install the harness holder mounting bolts (G) and the engine ground cable (H).
17. Install the three ignition coils to the rear cylinder head. See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair
18. Install the intake manifold. See: Intake Manifold/Service and Repair/Intake Manifold Removal and Installation
19. Install the strut brace. See: Body and Frame/Frame/Structural Brace/Service and Repair
