TL FWD V6-3.5L (2009)
2. Connect the knock sensor connector (A), then install the harness holder mounting bolts (B).
3. Install the injectors. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair
4. Install the intake manifold. See: Intake Manifold Removal and Installation
5. Inspect for fuel leaks. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode (do not operate the starter) so
the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in
the fuel line.