TL FWD V6-3.5L (2009)
36. Connect DLC terminal No. 14 to body ground with a jumper wire.
37. Check for continuity between PCM connector terminal A49 and body ground.
Is there continuity?
YES - Update the PCM if it does not have the latest software, See: Testing and Inspection/Programming and Relearning/PCM Update or
substitute a known-good PCM, See: Testing and Inspection/Initial Inspection and Diagnostic Overview then recheck. If the
symptom/indication goes away with a known-good PCM, replace the original PCM. See: Engine Control Module/Service and Repair/PCM
Replacement
NO - Repair open in the wire between the PCM (A49) and DLC terminal No. 14.
38. Try to start the engine.
Does the engine start and idle?
YES - Go to the F-CAN circuit troubleshooting. See: Testing and Inspection/Component Tests and General Diagnostics/F-CAN Circuit
Troubleshooting
NO -
-
If the starter cranks, turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode; and go to step 41.
-
If the starter does not crank, go to step 39.
39. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.