TL FWD V6-3.5L (2009)
Air Bag: Removal and Replacement
Driver's Airbag Replacement
Driver's Airbag Replacement
NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment See: Service and Repair for a
complete list of other parts that must also be replaced.
Removal
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from
the cable reel.
3. Remove the two TORX bolts (A) using a TORX T30 bit.
4. Remove the driver's airbag (B).
Installation
1. Place the driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B).
NOTE: Make sure the clearance (C) between the steering wheel and horn pad is the specified value.