TL FWD V6-3.5L (2009)
2. Connect the driver's airbag 4P connector (A) and horn switch 1P connector (B), then install the access panel (C) on the steering wheel.
3. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
4. Clear any DTCs. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
5. After installing the airbag, confirm proper system operation:
-
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6
seconds and then go off.
-
Make sure the horn work properly.
-
Make sure the steering wheel switches work properly.