TL FWD V6-3.5L (2009)
Installation
1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead.
2. If not already done, disconnect the negative cable from the battery, then wait at least 3 minutes.
3. Set the turn signal canceling sleeve (A) so that the projections (B) are aligned vertically.
4. Carefully install the cable reel (A) on the steering column shaft. Then connect 20P connector (B) to the cable reel, and connect the 4P connector
(C) to the dashboard wire harness 4P connector (D).
5. Install the steering column covers. See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and Repair
6. If necessary, center the cable reel (New replacement cable reels come centered.). Do this by first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (about three turns) until the arrow mark (A) on the cable reel label points straight up.
