TL FWD V6-3.5L (2009)
7. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown, and install the steering wheel on to the steering column shaft, making
sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel
or steering column shaft when installing the steering wheel.
8. Install and torque the steering wheel bolt (A), then reconnect the 20P connector.
9. Install the driver's airbag. See: Air Bag/Service and Repair/Removal and Replacement/Driver's Airbag Replacement
10. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
11. Clear any DTCs. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
12. After installing the cable reel, confirm proper system operation:
-
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator should come on for about 6
seconds and then go off.
-
After the SRS indicator has turned off, turn the steering wheel fully left and right to confirm the SRS indicator does not come on.
-
Make sure the horn and turn signal switches work properly.
-
Make sure the steering wheel switches work properly.
