TL FWD V6-3.5L (2009)
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions. See: Testing and Inspection
-
Assemble the washer, the collars, and the bushing on the upper anchor bolt and the retractor bolt as shown.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner connector is plugged in properly.
-
Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
-
Check for any DTCs that may have been set during repairs, and clear them.
Upper anchor bolt installation
Retractor bolt installation
Front Seat Belt Buckle
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before beginning work.
2. Remove the front seat. See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation
3. Lift up the front seat, disconnect the seat belt buckle switch connector (A), then detach the harness clips (B).
Driver's seat
