TL FWD V6-3.5L (2009)
18. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
19. Install the glass and the regulator in the reverse order of removal, and note these items:
-
Roll the glass up and down to make sure it moves freely without binding.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary. See: Window Glass/Front Door Window Glass/Adjustments
-
Do the power window control unit reset procedure. See: Testing and Inspection/Programming and Relearning
-
Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks. See: Window Glass/Front Door Window Glass/Adjustments
-
Test-drive the vehicle, and check for wind noise and rattles.
-
Make sure the power door locks and the windows operate properly.