TL FWD V6-3.5L (2009)
9. If you are reinstalling the old windshield, use a putty knife to scrape off the old adhesive, the upper clips, and the rubber dams from the
windshield. Clean the bonding surfaces on the inside face and the edge of the windshield with isopropyl alcohol. Make sure the bonding surface is
kept free of water, oil, and grease.
10. Before installing a new windshield, attach a new rearview mirror harness cover base to the inside face of the windshield. See: Body and
Frame/Mirrors/Service and Repair/Rearview Mirror Harness Cover Base Replacement
Cutting positions
11. Apply primer to the upper clip mounting areas on the windshield (C), and let it dry. Remove the adhesive backing and attach the rubber dam A, B
and the upper clips (D) to the inside of the windshield as shown:
-
Be sure the rubber dams and the upper clips line up with the alignment marks (E).
-
Be sure the index tabs (F) on the clips face the left side.
-
Be careful not to touch the windshield where adhesive will be applied.
