TL FWD V6-3.5L (2009)
12. Attach rubber dam C with adhesive tape to the inside surface of the windshield (A) as shown, using the edge of the black ceramic-coated area (B)
as a guide.
-
Be sure the rubber dam lines up with the alignment marks (D).
-
Be careful not to touch the windshield where the adhesive will be applied.
13. Attach the molding (A) with adhesive tape (B) to the upper edge of the windshield (C). Be careful not to touch the windshield where the adhesive
will be applied.
14. Attach the molding upper seal (A) with adhesive tape to the inside surface of the molding (B) as shown.
15. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and the body with a grease pencil at the four
