TL FWD V6-3.5L (2009)
points shown. Make sure the pins (B) of both upper clips (C) contact with the edge of the body holes. Be careful not to touch the windshield where
the adhesive will be applied.
16. Remove the windshield.
17. Apply a light coat of glass primer to the windshield (A) along the edge of the molding (B) and the rubber dams (C) as shown, then lightly wipe it
off with gauze or cheesecloth:
-
Apply glass primer to the molding.
-
Do not apply body primer to the windshield, and do not mix up the body and glass primer applicators.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the windshield properly, causing a leak after the
windshield is installed.
-
Keep water, dust, and abrasive materials away from the primed surfaces.
18. Carefully apply a light coat of body primer to any exposed paint or metal around the flange where new adhesive will be applied. Let the primer dry
for at least 10 minutes:
-
Do not apply body primer to any remaining original adhesive on the flange.
-
Be careful not to mix up the body and glass primer applicators.
-
Never touch the primed surfaces with your hands.
