ZDX V6-3.7L (2010)
Speaker: Service and Repair
Speaker Test/Replacement
Door Speaker
1. Remove the door panel:
-
Front See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door Panel
Removal/Installation
-
Rear See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door Panel
Removal/Installation
2. Remove the bolt (A). Then lift the speaker straight up to release the lower clips (B).
NOTICE
If you pull the speaker out too far from the door, you will damage the lower clips.
3. Disconnect the 2P connector (C), and remove the speaker.
4. Measure the resistance between terminals No. 1 and No. 2. There should be 2 Ohms.
5. If the resistance is not as specified, replace the door speaker.
Front Center Speaker
1. Remove the speaker lid (A), and disconnect the sunlight sensor connector (B).
2. Remove the self-tapping screws and the front center speaker (A).