ZDX V6-3.7L (2010)
Blind Spot Module: Testing and Inspection
BSI Radar Unit Aiming Inspection
BSI Radar Unit Aiming Inspection
Special Tools Required
-
Rim Frame 07AAJ-STKA150
-
Target Set 07AAJ-STKA160
-
Angle Gauge 07AAJ-STKA170
-
Stand Set 07AAJ-STKA220
Required Materials:
-
Masking tape
-
Fine-tip felt marking pen
Inspect the BSI radar unit aiming in these instances:
-
After replacing or removing and reinstalling one or both of the BSI radar units.
-
After repairing the body panel(s) where the BSI radar unit(s) mount.
-
For any of the following aiming axis DTCs:
-
B18B8: Left BSI Radar Unit Azimuth Off Alignment
-
B18B9: Right BSI Radar Unit Azimuth Off Alignment
Before Inspection:
-
Clean the surface of the BSI radar unit.
-
Make sure the vehicle does not have aftermarket suspension.
-
Make sure all the tires are the correct size, and set their pressures to the specifications shown on the doorjamb label.
-
Make sure the fuel tank is full.
-
Remove all cargo from the vehicle except the spare tire and tool kit.
-
Park the vehicle on level ground (within 1 degree) with at least 13.1 ft (4 m) of space on both sides and behind the vehicle. Do not do this
procedure with the vehicle on a lift or with the tires on steel plates or rollers.
-
Make sure the steering wheel is pointed straight ahead, and do not turn it after parking the vehicle.
-
Shift the transmission into P, and apply the parking brake.
1. Remove the rear bumper See: Body and Frame/Bumper/Rear Bumper/Service and Repair.
2. Set target (A) to stand set (B).
3. Set the target height by adjusting the rod to the same height as the dot (C) in the center of the BSI radar unit. Measure and note the height of the