ZDX V6-3.7L (2010)
dot from the floor.
4. Hold the plumb line against the dot (A) on the radar unit, and lower the plumb bob until it touches the floor. Mark the floor at that point (B).
5. Place the rim frame (A) by the rear wheel on the side of the vehicle you are aiming. Adjust the spacers (B, C) to fit against the wheel rim to mark
the rim frame parallel with the wheel.
6. Assemble the two sections of the straightedge, then place the hole in the end of the straightedge over the mark on the ground that you made in step
4. Slide the rim frame rearward until the base of the rim frame and the straightedge meet as shown.
NOTE:
-
Make sure the spacers are still touching the wheel rim.
-
Set the straightedge according to the arrow (A).