ZDX V6-3.7L (2010)
9. With the appropriate degree setting on the angle gauge up, set the angle gauge against the radar unit. Align the cutout in the angle gauge with the
dot (B) on the radar unit.
10. Turn on the laser pointer (A), and set it on the angle gauge so that the beam shines on the target (B).
CAUTION
Do not aim the laser beam at anyone's eyes.
11. Check the points (A) where the laser beam hits the target (B):
-
If the laser beam is within the target, aiming of the BSI radar unit is correct, go to step 12.
-
If the laser beam is out of the target range, do the BSI radar unit mounting area check See: BSI Radar Unit Mounting Area Check.