ZDX V6-3.7L (2010)
15. Install the glass and the regulator in the reverse order of removal, and note these items:
-
If the clip is damaged or stress-whitened, replace it with a new one.
-
Make sure that each connector is plugged in properly.
-
Push the clips and the hooks into place securely.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Roll the glass up and down to make sure it moves freely without binding.
-
Adjust the position of the glass as necessary See: Front Door/Front Door Window Glass/Adjustments.
-
Make sure the power door lock and the power window operate properly.
-
When reinstalling the door panel, make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal
out water.
-
Check for water leaks See: Front Door/Front Door Window Glass/Adjustments.
-
Test-drive the vehicle, and check for wind noise and rattles.