ZDX V6-3.7L (2010)
6. Detach the clips (A, B) that hold the lower rear window (C), then carefully remove the window.
7. Scrape smooth the old adhesive with a knife until there is a thickness of about 2 mm (0.08 in) on the bonding surface around the entire lower rear
window opening flange. Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
8. Clean the body bonding surface with a shop towel dampened in isopropyl alcohol. After cleaning, do not allow oil, grease, and water to contact on
the surface.
9. If you are reinstalling the old window, scrape off all of old adhesive, the clips, and the rubber dam from the lower rear window with a putty knife.
Clean the bonding surfaces on the inside face and the edge of the lower rear window with isopropyl alcohol. Make sure the bonding surface is kept
free of water, oil, and grease.
10. Apply glass primer to the clip mounting areas on the lower rear window (A), and let it dry. Attach the glass molding (B) and the clips (C) with the
adhesive tape to the inside face of the lower rear window as shown. Be careful not to touch the lower rear window where the adhesive will be
applied.
