ZDX V6-3.7L (2010)
Power Trunk / Liftgate Control Module: Service and Repair
Power Tailgate Control Unit Input Test/Replacement
NOTE:
-
Before testing the power tailgate control unit, troubleshoot the multiplex integrated control system first using B-CAN System Diagnosis Test Mode
A See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General
Diagnostics/Troubleshooting - B-CAN System Diagnosis Test Mode A.
-
All connector views are wire side of female terminals.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the left rear side trim See: Interior Moulding / Trim/Trim Panel/Service and Repair/Interior Trim Removal/Installation - Rear Side Area.
3. Disconnect power tailgate control unit connectors A (5P), B (20P), and C (14P) in the order shown.
4. Inspect all the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 5.
5. Reconnect all connectors to the power tailgate control unit, and do the following input tests:
-
If the test indicates a problem, find and correct the cause, then recheck the system.