ZDX V6-3.7L (2010)
10. Temporarily install the quarter pillar trim (without the upper clip) to check the overlap between the trim and the headliner See: Restraint
Systems/Air Bag Systems/Service and Repair. Remove the trim, and if necessary, adjust the overlap.
11. Carefully install the new upper clip (A) to the quarter pillar upper trim (B). Be sure that the grommet (C) is nearest to the top of the pin (D) as
shown.
12. Reinstall the quarter pillar trim (A).
1. Insert the power tailgate rod (B) into the trim.
2. For some models: Reconnect the satellite speaker connector (C).
3. Place the trim over the quarter pillar (D) and fit the upper clip (E) into the hole (F) in the quarter pillar, then lightly push the trim into place.
NOTE:
-
Make sure the side curtain airbag is not tucked under the clips or the trim ribs.
-
Do not push too hard on the quarter pillar trim. If you push too hard, the clip is damaged, and it will not hold the trim properly.
-
Gently tug on the quarter pillar trim to verify that all clips (G, H) are securely fastened.
