ZDX V6-3.7L (2010)
Trim Panel: Service and Repair
Interior Trim Removal/Installation - Rear Side Area
Interior Trim Removal/Installation - Rear Side Area
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
Rear Side Trim Panel
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the cargo area side lid (A).
2. Remove these items:
-
Rear seat side bolster See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Front floor lid See: Interior Trim Removal/Installation - Cargo Area
-
Rear floor lid See: Interior Trim Removal/Installation - Cargo Area
-
Tailgate weatherstrip, as needed See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Weatherstrip/Service and Repair
-
Rear trim panel See: Interior Trim Removal/Installation - Cargo Area
3. Fold down the seat-back.
4. Remove the rear side trim panel (A).
1. Pry out the cover (B) and remove the screw, then remove the tie down hook (C).
2. Detach the clips (D) from the front area of the trim panel.
3. Pull back the upper edge of the trim panel to release the hooks (E) from the quarter pillar trim (F).
4. Pull out the trim panel back by hand to detach the clips (G).
5. Pull the front area of the trim panel inward to release it from the rear seat-back striker (H).
6. Disconnect the cargo area light connector (I).