ZDX V6-3.7L (2010)
Brake Rotor/Disc: Service and Repair
Rear Brake Disc Replacement
Rear Brake Disc Replacement
NOTE: Keep grease away from the brake disc/drum and the brake pads.
1. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the rear wheel.
3. Release the parking brake.
4. Remove the brake caliper bracket mounting bolts (A), then remove the caliper assembly (B) from the knuckle. To prevent damage to the caliper
assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.
5. Remove the brake disc/drum flathead screws (A).
6. Remove the brake disc/drum (B) from the hub bearing unit.
NOTE:
-
Remove the access plug (C), then if necessary, turn the adjuster nut (D) with a flat-tip screwdriver until the shoes become loose.
-
If the brake disc/drum is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (E) into the brake disc/drum to push it away from the hub
