ZDX V6-3.7L (2010)
10. Remove the thrust cover (A), then remove the front camshaft (B).
11. Install the front camshaft in the reverse order of removal. Always use a new O-ring (C). Apply new engine oil to the journals and the cam lobes.
12. Apply new engine oil to the threads of the camshaft pulley mounting bolt, then install the front camshaft pulley See: Cylinder Head
Assembly/Service and Repair/Overhaul/Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley Installation.
13. Install the front rocker arm assembly, then tighten the mounting bolts See: Cylinder Head Assembly/Service and Repair/Overhaul/Camshaft,
Rocker Arm Assembly, Camshaft Seal, and Pulley Installation.
14. Install the timing belt See: Timing Components/Timing Belt/Service and Repair/Timing Belt Installation.
15. Adjust the valve clearance See: Cylinder Head Assembly/Valve Clearance/Adjustments.
16. Install the EGR valve stud bolts, then install the EGR valve See: Powertrain Management/Emission Control Systems/Exhaust Gas
Recirculation/EGR Valve/Service and Repair.
17. Connect the radiator hoses.
18. Install the battery base See: Service and Repair/Engine Installation.
19. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
20. Fill the radiator with engine coolant, and bleed the air from the cooling system See: Cooling System/Coolant/Service and Repair.
21. Do the crankshaft position (CKP) pattern clear/CKP pattern learn procedure See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview.
Rear
1. Relieve the fuel pressure See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair.
2. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
3. Drain the engine coolant See: Cooling System/Coolant/Service and Repair.
4. Remove the air cleaner See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair.
5. Remove the quick-connect fitting cover, then disconnect the fuel feed hose See: Cylinder Head Assembly/Service and Repair/Removal and
Replacement/Cylinder Head Removal.
6. Disconnect the heater hoses.