ZDX V6-3.7L (2010)
13. Apply new engine oil to the threads of the camshaft pulley mounting bolt, then install the rear camshaft pulley See: Cylinder Head
Assembly/Service and Repair/Overhaul/Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley Installation.
14. Install the rear rocker arm assembly, then tighten the mounting bolts See: Cylinder Head Assembly/Service and Repair/Overhaul/Camshaft,
Rocker Arm Assembly, Camshaft Seal, and Pulley Installation.
15. Install the timing belt See: Timing Components/Timing Belt/Service and Repair/Timing Belt Installation.
16. Adjust the valve clearance See: Cylinder Head Assembly/Valve Clearance/Adjustments.
17. Install the EVAP canister purge joint with the bracket, then connect the EVAP canister hose.
18. Connect the heater hoses.
19. Connect the fuel feed hose, then install the quick-connect fitting cover See: Cylinder Head Assembly/Service and Repair/Removal and
Replacement/Cylinder Head Installation.
20. Install the air cleaner See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair.
21. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
22. Inspect for fuel leaks. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode (do not operate the starter) so
the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in
the fuel line.
23. Fill the radiator with engine coolant, and bleed the air from the cooling system See: Cooling System/Coolant/Service and Repair.
24. Do the crankshaft position (CKP) pattern clear/CKP pattern learn procedure See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview.