ZDX V6-3.7L (2010)
1. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
2. Install the tire pressure sensor (A) and the washer (B) to the wheel (C), and tighten the valve stem nut (D) finger tight. Make sure the pressure
sensor is resting on the wheel.
NOTE: Install the tire pressure sensor so that the sensor housing surface (E) should not exceed the protrusion (F) of the wheel to prevent the sensor
housing from being caught on the bead of the tire when assembling the tire. Be sure to always mount the tire pressure sensor with the feet (G) in the
downward position toward the wheel.
3. Tighten the valve stem nut to the specified torque while holding the tire pressure sensor.
NOTE:
-
Do not use air or electric impact tools to tighten a valve stem nut.
-
Do not twist the tire pressure sensor to adjust its position with the wheel, as this will damage or deform the valve stem grommet.
4. Lube the tire bead sparingly, with a paste-type tire mounting lubricant, and position the wheel so that the tire machine (A) is next to the valve stem
