ZDX V6-3.7L (2010)
7. Detach the clip (C). Pull out the side airbag harness in the seat-back cover, then remove the two mounting nuts (D) and the side airbag (E).
Installation
NOTE:
-
If the side airbag lid is secured with tape, remove the tape.
-
Do not open the lid on the side airbag cover.
-
Use new mounting nuts tightened to the specified torque.
-
If you are replacing a deployed airbag, replace the attachment wire A and B.
-
Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
-
Be sure to install the harness so that it is not pinched or interfering with other parts.
1. Place the side airbag (A) on the seat-back frame. Install the side airbag with two new mounting nuts (B).
2. Install the airbag attachment wire B (C) in the seat-back frame (D).
3. Install the side airbag harness into the seat-back cover, then install the clip (E).