ZDX V6-3.7L (2010)
21. Pry back each brush spring with a screwdriver, then position the brush on the brush holder about halfway out of its holder. Release the spring to
hold it in place.
NOTE: To seat the new brushes. Slip a strip of #500 or #600 sandpaper, with the grit side up, between the commutator and the each brush, and smoothly
turn the armature. The contact surface of the brushes will be sanded to the same contour as the commutator.
22. Install the brush holder assembly. Next pry back each brush spring again, and push each brush down until it seats against the commutator, then
release the spring against the end of the brush.
23. Install the end cover to retain the brush holder.