ZDX V6-3.7L (2010)
9. Mark the cam positions of the adjusting bolt (A) and the adjusting cam plate (C) with the frame.
10. Remove the self-locking nut (D) while holding the adjusting bolt, then remove the adjusting cam plate, the adjusting bolt, and lower arm B.
NOTE: Use a new adjusting bolt and a new self-locking nut during reassembly.
11. Install lower arm B in the reverse order of removal, and note these items:
-
First install all of the suspension components, and lightly tighten the bolts and the nuts, then raise the suspension to load it with the vehicle's
weight before fully tightening to the specified torque.
-
Align the cam positions of the adjusting bolt and the adjusting cam plate with the marked positions on the frame when tightening the
self-locking nut.
-
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.
12. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
