ZDX V6-3.7L (2010)
Axle Shaft Assembly: Overhaul
Front Driveshaft Disassembly
Front Driveshaft Disassembly
Special Tools Required
-
Threaded Adapter, 26 x 1.5 mm 07XAC-001030A
-
Slide Hammer 5/8''-18 UNF, commercially available
-
Bearing Puller, commercially available
-
Boot Band Pliers, commercially available
Inboard Joint Side
1. Remove the boot bands. Be careful not to damage the boot.
-
If the boot band is a double loop type (A), lift up the band end (B), and push it into the clip (C).
-
If the boot band is a low profile type (D), pinch the boot band using commercially available boot band pliers (E).
2. Make marks (A) on each roller (B) and the inboard joint (C) to identify the locations of the rollers to the grooves in the inboard joint.
NOTE: Do not engrave or scribe any marks on the rolling surface.