ZDX V6-3.7L (2010)
3. Remove the inboard joint on a clean shop towel (D). Be careful not to drop the rollers when separating them from the inboard joint.
4. Make marks (A) on the spider (B) that match the marks on the rollers, then remove the rollers.
NOTE: Do not engrave or scribe any marks on the rolling surface.
5. Remove the snap ring (C).
6. Make marks (D) on the spider and the driveshaft (E) to identify the position of the spider on the shaft.
7. Remove the spider.
NOTE: If necessary, use a commercially available bearing puller while being careful not to damage the spider.
8. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the inboard boot.
9. Remove the inboard boot. Be careful not to damage the boot.
