ZDX V6-3.7L (2010)
17. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5-10 mm (0.20-0.39 in) tail protruding from the clip.
18. Bend the band end (A) by tapping it down using a hammer.
NOTE:
-
Make sure the band and the clip do not interfere with anything on the vehicle, and the band does not move.
-
Clean any grease remaining on the surrounding surfaces.
19. Repeat steps 11 through 18 for the band on the other end of the boot.
20. Install a new low profile band (A) onto the boot (B), then hook the tab (C) of the band.