ZDX V6-3.7L (2010)
3. Make sure to check the size of a new stop ring.
NOTICE
To avoid driveshaft and vehicle damage, make sure you install a new stop ring.
4. Install the stop ring (A) into the driveshaft groove (B).
5. Pack about 35 g (1.23 oz) of grease included in the new outboard boot set into the driveshaft hole in the outboard joint.
NOTE: If you are installing a new outboard joint, the grease is already installed.
6. Insert the driveshaft (A) into the outboard joint (B) until the stop ring (C) is close to the joint.