ZDX V6-3.7L (2010)
2. Install a new ear clamp band (B) and the outboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the outboard
boot.
3. Make sure to check the size of a new stop ring.
NOTICE
To avoid driveshaft and vehicle damage, make sure you install a new stop ring.
4. Install the stop ring (A) into the driveshaft groove (B).
5. Pack about 35 g (1.23 oz) of grease included in the new outboard boot set into the driveshaft hole in the outboard joint.
NOTE: If you are installing a new outboard joint, the grease is already installed.