ZDX V6-3.7L (2010)
Axle Shaft Assembly: Removal and Replacement
Front Driveshaft Installation
Front Driveshaft Installation
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean.
1. Apply about 5 g (0.18 oz) of moly 60 paste (P/N 08734-0001) to the contact area (A) of the outboard joint and the front wheel bearing.
NOTE: The paste helps prevent noise and vibration.
2. Install a new set ring (A) into the set ring groove (B) of the left driveshaft inboard joint.
3. Install a new set ring (A) into the set ring groove (B) of the intermediate shaft.