ZDX V6-3.7L (2010)
4. Apply 2.0-3.0 g (0.071-0.106 oz) of super high temp urea grease (P/N 08798-9002) to the whole splined surface (A) of the right driveshaft. After
applying grease, remove the grease from the splined grooves at intervals of 2-3 splines and from the set ring groove (B) so that air can bleed from
the intermediate shaft.
5. Clean the areas where the driveshaft contacts the differential thoroughly with solvent, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent.
6. Insert the inboard end (A) of the driveshaft into the differential (B) or the intermediate shaft (C) until the set ring (D) locks in the groove (E).
NOTE: Insert the driveshaft horizontally to prevent damaging the oil seal.