ZDX V6-3.7L (2010)
7. Install the outboard joint (A) into the front hub (B) on the knuckle.
8. Wipe off any grease contamination from the ball joint tapered section and threads, then install the knuckle (A) onto the lower arm (B). Be careful
not to damage the ball joint boot (C). Wipe off the grease before tightening the nut at the ball joint. Torque a new castle nut (D) to the lower
torque specification, then tighten it only far enough to align the slot with the ball joint pin hole.
NOTE:
-
Make sure the ball joint boot is not damaged or cracked.
-
Do not align the nut by loosening it.
