ZDX V6-3.7L (2010)
Axle Shaft Assembly: Removal and Replacement
Rear Driveshaft Removal
Rear Driveshaft Removal
Special Tools Required
-
Driveshaft Remover 07AAD-S3VA000
-
Ball Joint Thread Protector, 12 mm 07AAF-SDAA100
-
Ball Joint Remover, 28 mm 07MAC-SL0A202
NOTE: Be careful not to damage the brake hose, sensor, and harness.
1. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the rear wheels.
3. Pry up the stake (A) on the spindle nut (B), then remove the nut.
4. Remove the rear wheel speed sensor (A) and the wheel sensor harness bolt (B).
5. With active damper system: Remove the suspension stroke sensor See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair.