ZDX V6-3.7L (2010)
7. Carefully remove the upper rear window.
8. Scrape smooth the old adhesive with a knife until there is a thickness of about 2 mm (0.08 in) on the bonding surface around the entire upper rear
window opening flange:
-
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
-
Remove the fasteners from the body.
9. Clean the body bonding surface with a shop towel dampened in isopropyl alcohol. After cleaning, do not allow oil, grease, and water to contact on
the surface.
10. If you are reinstalling the old upper rear window, scrape off all of old adhesive, the spacers, the fasteners, and the rubber dams from the upper rear
window with a putty knife. Clean the bonding surfaces on the inside face and the edge of the upper rear window with isopropyl alcohol. Make sure
the bonding surface is kept free of water, oil, and grease.
11. Apply glass primer to the edge of the upper rear window (A) where the upper molding (B) will be attached as shown. Attach the upper molding
with adhesive tape to the lower edge of the upper rear window:
-
Be careful not to touch the window where the adhesive will be applied.
-
Be sure the upper molding line up with the alignment mark (C). If necessary, cut off the excess upper molding.
