Check the clutch pedal travel

Move onto step 2

• Restore the operation of the clutch pedal

End of diagnosis

Check the condition and the centering of the front crossmember and the engine supports and connecting rod

Move onto step 3

• Bed in the fixings: loosen the bolts, centre them in their housings and tighten them to torque

End of diagnosis

• Bed in the fixings: loosen the bolts, centre them in their housings and tighten them to torque

End of diagnosis

• Bed in the fixings: loosen the bolts, centre them in their housings and tighten them to torque Op. 4410D13

End of diagnosis

Verify:

• clutch disc wear or 'vitrification'
• that there is no damage to the pressure plate diaphragm spring
• that there is no damage to the flexible coupling springs

Move onto step 4

• Replace the clutch plate Op. 1810A20

End of diagnosis

• If there is oil or grease, replace the gearbox input oil seal Op. 2110C24

End of diagnosis

• Replace the flywheel Op. 1024B22

End of diagnosis

Check for excess grease on the clutch plate hub bushes and the gearbox main shaft

Move onto step 5

• Restore the correct lubrication for the bushes If necessary, replace the clutch plate Op. 1810A20 or the gearbox main shaft

End of diagnosis

Check the condition of the flywheel (in particular, the state of the surface, making sure that there is no overheating, uneven wear, incisions or material removed)

Move onto step 6

• Replace the flywheel Op. 1024B22

End of diagnosis

Check that the fault is no longer present

Incorrect selection of diagnostic procedure

Incorrect selection of diagnostic procedure