Welding and finishing the sheet metal (page 2 of 2)
- Make
- Alfa Romeo
- Model
- 155 Factory Service Manual
- Year
- 1992–1998
- Section
- Positioning
BodyworkWelding and finishing the sheet metal · page 2 of 2
- Carry out filling welds using a MIG welder.
- Using a spot welder operate as shown in the illustration.
- Using an abrasive grind wheel remove and level the residues left by welding.
- Install the REAR TRIM and check the correct positioning of the components.
Parts & tools for this job For 1992 Alfa Romeo 155
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Alfa Romeo touch up paint
- PARTPanel clip assortmentSearch: Alfa Romeo panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.