Firstly check the moving window glass is properly closed.

Check that the noise is actually coming from one of the front doors by carrying out the preliminary check for locating noises See Test 70A Rustle detection (preliminary detection)

Move onto step 1

• Check the diagnostic table corresponding to the area located.

End of diagnosis

Check the wind/dust seal is properly fitted

Move onto step 2

• Fit the sealing strip correctly Op. 7005A46

End of diagnosis

Carry out the detailed check for locating wind noise from the front doors See Test 7005A Location of front door wind noises and identify the area where the noise is coming from.

No wind noise is locatedMove onto step 3

• Check for sealant between the wing and the pillar under the wheel arch

End of diagnosis

• Check the condition of the door compartment seal in that area and ensure it is bonded properly to the body Op. 7005A34

End of diagnosis

• Check the condition of the door compartment seal in that area and ensure it is bonded properly to the body Op. 7005A34

End of diagnosis

• Adjust the door hinges Op. 7005A14 .

End of diagnosis

• Adjust the door hinges Op. 7005A14

End of diagnosis

• Check the glass scraper is undamaged and correctly fitted Op. 7005D26

End of diagnosis

• Check the condition of the seal between mirror and door and make sure it is correctly fitted. Adjust or replace the actual mirror Op. 7005R30

End of diagnosis

Check that the fault is no longer present

End of diagnosis

Incorrect selection of diagnostic procedure