FRONT CRANKSHAFT COVER OIL SEAL - R.R.

Operation 1020D18 · OIL SEALS ON CRANKSHAFT

2.2 JTS

Removing

- Position the vehicle on a lift.

Op. 4450B04 RIGHT FRONT WHEEL - R.R

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 1092G10 SINGLE ENGINE BELT - R.R

Op. 1092A10 CRANKSHAFT PULLEY - R + R

- Release and remove the oil seal from the front crankshaft cover.

Take care not to damage the sealing surfaces during the "destructive" removal of the oil seal.

Refitting

1. Fit a new oil seal (1a) on the crankshaft front cover using the tool (1b).

Before installation, spread the lip of the new seal lightly with white silicone grease.

Op. 1092A10 CRANKSHAFT PULLEY - R + R

Op. 1092G10 SINGLE ENGINE BELT - R.R

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 4450B04 RIGHT FRONT WHEEL - R.R

- Remove the vehicle from the lift.

3.2 JTS

Removing

- Position the vehicle on a lift.

Op. 4450B04 RIGHT FRONT WHEEL - R.R

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

Op. 1008B10 POWER UNIT FRONT SUPPORT FLEXIBLE MOUNTING (TIMING SIDE) - REPLACE

Op. 1008A46 POWER UNIT RIGID SUPPORT - TIMING SIDE - R.R.

Op. 1092G10 SINGLE ENGINE BELT - R.R

Op. 1092A10 CRANKSHAFT PULLEY - R + R

- Release and remove the oil seal from the front crankshaft cover.

Take care not to damage the sealing surfaces during the "destructive" removal of the oil seal.

Refitting

1. Fit a new oil seal (1a) on the crankshaft front cover using the tool (1b).

Before installation, spread the lip of the new seal lightly with white silicone grease.

Op. 1092A10 CRANKSHAFT PULLEY - R + R

Op. 1092G10 SINGLE ENGINE BELT - R.R

Op. 1008A46 POWER UNIT RIGID SUPPORT - TIMING SIDE - R.R.

Op. 1008B10 POWER UNIT FRONT SUPPORT FLEXIBLE MOUNTING (TIMING SIDE) - REPLACE

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 4450B04 RIGHT FRONT WHEEL - R.R

- Remove the vehicle from the lift.

2.4 JTD 20v

- On this car, it is not possible to remove/refit the crankshaft front oil seal cover on the car.

To perform this operation, remove/refit the power unit

Op. 1004B10 POWER UNIT WITH MANUAL GEARBOX - R.R

and then work at the bench, customising the engine service procedures for this operation.