POWER UNIT INTERMEDIATE MOUNT FLEXIBLE BLOCK - REPLACE

Operation 1008B20 · POWER UNIT SUPPORT MOUNTINGS

2.2 JTS

Removing

Op. 4450B12 FRONT WHEELS (TWO) - R+R

Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R

Op. 4410D10 FRONT SUSPENSION FRAME - R+R

(proceed with the removal only without carrying out the dismantling at the bench).

Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY

Mark the position of the flexible mounting for the power unit rear support in relation to the front suspension frame.

1. Undo the bolts (1a) and remove the flexible mounting for the power unit rear support (1b) from the front suspension frame.

Refitting

1. Place the power unit rear support flexible mounting (1a) in its housing and secure it by tightening the new bolts (1b) to the recommended torque.

Op. 4410C10 FRONT SUSPENSION ANTI-ROLL BAR - R+R - CHECK WHEEL GEOMETRY SEPARATELY

Op. 4410D10 FRONT SUSPENSION FRAME - R+R

Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R

Op. 4450B12 FRONT WHEELS (TWO) - R+R