REAR RIGID MOUNT - R R

Operation 1008A44 · POWER UNIT FASTENINGS

2.2 JTS

Removing

- Position the vehicle on a lift.

1. Undo the bolts (1a) and disconnect the intermediate exhaust pipe (1b), exhaust manifold and catalytic converter side.

1. Undo the bolts fixing the lower reaction rod for the power unit, engine crankcase sump side.

1. Undo the bolts fixing the power unit rear support flexible mounting, rigid support side.

1. Undo the bolts (1a) and remove the rigid power unit rear support (1b).

Refitting

1. Place the power unit rigid rear support (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

1. Tighten the bolts fixing the power unit rear support flexible mounting, rigid support side to the recommended torque.

1. Tighten the bolts fixing the lower reaction rod for the power unit, engine crankcase sump side to the recommended torque.

1. Connect the intermediate exhaust pipe (1b), exhaust manifold side with the catalytic converter and tighten the bolts (1b) to the recommended torque.

- Remove the vehicle from the lift.