Procedure

Procedure

16. Select ECO
17. Select AC
18. Select fan speed 3
19. Select fan speed 2
20. Select MAX temperature
    allow in-car temperature to stabilise
    (Passenger side underscuttle panel must be in place)
21. Select MIN temperature and mid face level
22. Select DEMIST and full heat
23. System check now complete

Normal System Reaction

Blower flaps revert to fresh air position

Engine revs change then stabilise

Small increase in fan speed

Fan speed lower
Centre vent and dash end cold
footwell cool

Hot air from footwell,
warm from dash end

System goes to full cooling automatically
Cold air from all vent except from screen vent
Centre vent open
Blower at re-circulation

Demist vents open, centre vent closes and
blower flaps revert to fresh air position

System good.

Note: A small amount of air will bleed from the ends of the demist-defrost vents in all cases, but there should be no leak along the length of the vents.