Disconnect hydraulic Pipes

6. Disconnect the hydraulic pipes.

Connect feed and return hydraulic pipes to create an hydraulic loop.

Creating hydraulic loops will enable the hydraulic rams to continue to operate.

The hydraulic pipes are numbered, i.e. connect pipes, feed to return, numbered 32 together, etc.

Disconnect hydraulic Pipes

7. Disconnect both ends of the hydraulic ram and withdraw the ram.

Installation

1. Connect the ram to it’s mounts.
2. Connect the hydraulic pipes.

The hydraulic pipes are numbered, i.e. connect pipes, feed to return, numbered 32 together, etc.

Connect hydraulic Pipes

3. LH ram only.
4. Connect the wiring harness plug (x1).
5. Feed the wiring harness cable (x1) through into the boot area.

Warning
Take care to avoid sharp edges.

1. Install the pump and pump plate unit.
2. Remove the roof lid support.
3. Connect the vehicle battery. Open the boot lid.
4. Connect the boot area wiring harness plug.

Disconnect plug from the front of the mech